Total Quality Management

121. Which of the following is not a type of attribute chart?

1. P chart
2. C chart
3. U char
4. X bar chart

View answer

122. The thickness of aluminum sheet is specified to be of 6±2 mm. The Upper Specification Limit and Lower Specification Limit for the sheet are:

1. 4mm, 8mm
2. 8mm, 4mm
3. 6mm, 8mm
4. 4mm, 6mm

View answer

123. Failure Mode and Effects Analysis, which prioritizes different sources of error, is used in ______________ stage.

1. Define
2. Measure
3. Improve
4. Analyze

View answer

124. In a six sigma improvement project the least experienced individuals are:

1. Green Belt
2. Black belts
3. Red Belts
4. Master Black Belts

View answer

125. The ______________ diagram starts with one item which then branches of into two or more items. This diagram is used to breakdown broad categories into finer levels of detail.

1. Affinity
2. Tree
3. Relations
4. Matrix

View answer

126. Lot tolerance percent defective (LTPD) is a level of lot quality specified by the ______________.

1. Consumer
2. Producer
3. Supplier
4. Sampling Plan

View answer

127. Machine wear and tear is ______________ source of variation.

1. Random
2. Natural
3. Assignable
4. Cannot be determined

View answer

128. Pattern in control charts which show the tendency to cluster around central line is termed as:

1. Stratification
2. Mixture
3. Cyclic pattern
4. Shift in process level

View answer

129. When output product of several sources is fed into a common stream, the pattern of the control chart expected is:

1. Stratification
2. Trend
3. Mixture
4. Cyclic Pattern

View answer

130. A fan blade is specified by length and thickness. While sampling, it was found that for one particular blade, the length was non-conforming while the thickness was as per specifications. Should the blade be considered non-conforming for construction of a p chart?

1. Yes
2. No

View answer